The printed instructions and product labels contain model specific information important warnings and safety notices. Please locate your water heaters serial number and enter it in the box below.
The serial number may be found on the label near the bottom of the water heater.
How to turn up hot water heater whirlpool.
If the temperature is properly set then one of the thermostats is to blame.
Usually these connect to the top two screws of the upper thermostat.
Make sure the gas supply valve is turned on.
Turn the circuit breaker back on and check for voltage on the top two screws of the upper thermostat.
Keep the knob pushed in while repeatedly clicking the spark igniter button.
If the status light is not flashing try lighting the pilot using the instructions on the water heaters label.
If you lack the necessary skills to install troubleshoot or repair the water heater get help from a qualified person.
Important read and follow the printed installation instructions that came with your water heater.
It should not be set above 125 degrees f.
Identify the power supply wires.
Any element that is getting power while the water is too hot has a faulty thermostat.
One easy way to care for it is to properly set the water heaters temperature.
When lighting the pilot make sure the knob on the gas control valve is fully pushed in.
Remove the water heaters upper access panel.
To point you in the right direction well need to first identify your water heater.
Check the temperature set screw.
Gas valve water heaters are really easy to adjust.
Carefully remove the insulation and plastic cover.
Find the knob on the valve and set the temperature between 115.
Troubleshoot a water heater that puts out overly hot water.
Check for power at both elements.
No comments:
Post a Comment