If you can remove the batteries. The detector will chirp one time to indicate power.
Some may run on electricity no battery and when you detach from ceiling the power is removed.
How to turn off smoke detector power.
Open the cover and remove the battery.
If you have a hardwired alarm make sure to switch the power breaker off first before proceeding with the reset and then turn it back on afterward.
Mount the ladder and ensure that the power to the smoke detector has been shut off by using a noncontact circuit tester.
Place the battery in the smoke detector reconnect the power cable and put the smoke detector back on its mounting bracket.
If you cant reach the alarms stand on a sturdy chair to take them down.
Remove the battery from the smoke detector if there is a battery.
Install a fresh battery and reconnect the smoke alarm back to the circuit.
Replace malfunctioning smoke detectors.
How to reset a chirping smoke alarm turn off the breaker controlling the alarm circuit or disconnect the smoke detector from.
How to disable a fire alarm turning off a battery powered smoke detector find the activated unit.
Take out the smoke alarm battery if you cant tell which circuit breaker operates the alarm.
Turn the breaker on.
Press down the raised end of the circuit breaker to shut it off.
Press and hold the reset button for 15 to 20 seconds.
Take down your smoke alarms if the alarm doesnt stop.
Reach behind each alarm and unclasp the connector thats connecting the wiring in the alarm to the wiring in the walls.
Inspect the detector wires.
Depending on the type of detector you have.
Remove the detector from its mounting bracket and unplug the power supply.
Your first step is to find the device thats going off and reset it by pressing and holding the reset button.
One at a time pull each alarm away from the wall or ceiling.
Replace or remove the batteries if the alarm wont reset.
Open the door of your electrical panel box.
But once youre sure its a false alarm your approach should vary based on the type of power your smoke alarm uses.
Turn off the power to the smoke detector at your circuit breaker.
If that doesnt work take the smoke alarm down.
If resetting the alarm did not work there may be dust or dirt stuck between the wall and the detector inhibiting the sensors.
How to turn off the circuit breaker for a smoke alarm step 1.
No comments:
Post a Comment