Open the choke completely by pressing the plunger all the way in against the carburetor housing. Remove the air filter from the air filter cover.
The red screw adjusts the high speed setting and the white screw controls the low speed setting.
How to turn on a mantis tiller.
Crank with the starter cord again and the mantis two cycle tiller should run.
Replace the air filter into the air filter cover.
Be sure the filter fits.
Turn the ignition switch on.
Let the engine warm up two or three minutes before tilling.
Further adjusting it up and down until the engine barely 4 strokes under full throttle under no load.
Heres how to check or replace the air filter.
Last year i paid a small engine mechanic 65 to rebuild the carburetor on my then 7 year old mantis tillercultivator when i couldnt get it to start.
Thanks for watching and be.
See how to position the mantis tiller tines for tilling or for cultivating.
This spring i couldnt get the tiller to.
The mantis tiller tines are guaranteed for life against breakage.
I will walk you through the steps to troubleshoot any 2 stroke engine that will not start.
Remove the air filter and air filter cover.
Remove the wing nut to take off the air filter cover.
If your mantis has carburetor screws then you should have the main mixture screw you tuned by running the engine at full throttle.
How to fix and tune mantis tiller carb.
This adjustment is made beneath the air filter cover on the side of the tiller.
The mantis tiller carburetors are adjusted using a red and a white screw located behind the air filter cover near the black choke button on the right side of the engine.
2 stroke mantis tiller that bogs down or stalls when using the throttle try watching this video i managed to fix mine hopefully this will help you.
After sitting all winter engines like this can be stubborn in the spring.
No comments:
Post a Comment